Viewing 6 posts - 25 through 30 (of 48 total)
  • Author
    Posts
  • westie California
    Participant
    Post count: 138

    Dr Corenman,

    I currently have a plate in front at C3-4, however all rods were removed from C3 thru T2 Posteriorly. That’s correct, I did have an ACDF at C3-4 segment along with posterior laminectomy at this level. I’m told fusion is solid at this level.

    westie California
    Participant
    Post count: 138

    I should probably get a second set of eyes to look at my CT scan. If I understand correctly, a properly fused segment should not develop bone spurs?

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    Correct, a properly fused segment should not develop bone spurs. However, not every ACDF successfully removes all the uncovertebral joint spur. There could have been residual spur remaining. It does make it difficult to decompress the nerve root if there is a solid ACDF but the good news is you could have a substantial or even full facetectomy at C3-4 due to the anterior fusion which can be helpful to decrease the nerve root compression.

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
    westie California
    Participant
    Post count: 138

    Thank you so much Dr. Corenman! I can’t say enough, thanks.

    I have a sit down with my surgeon in September and I will see if he can perform C3-4 facetectomy the same day T1-T2 revision to address psuedorthosis. .

    Have a wonderful evening.

    westie California
    Participant
    Post count: 138

    I want to confirm for C4, C5 and C6, levels also had ACDFs with laminectomies however those levels also has unconvertebral spurring as noted below on my CT scan with mild foraiminal narrowing should not be addressed?

    EXAM/TECHNIQUE: CT Cervical Spine Without. Protocol: Routine. Iterative reconstruction wasutilized to minimize dose.COMPARISON: Outside MRI Cervical Spine 5/19/2018 .FINDINGS:Postsurgical Changes: Postsurgical fusion changes, appears to reflect a revision/addition since 5/19/2018,now appears to involve C3-T1 with multilevel postoperative hardware and decompressive laminectomies. Hardware appears intact, appropriately positioned without evidence of failure or loosening. Bony fusionappears solid at C3-4 through C7-T1.Alignment: Lordotic straightening.Vertebrae: Normal in height.Soft Tissues: Expected postoperative changes.Disc Spaces: C2-3: Tiny central disc herniation. There is associated minimal mass effect on the anterior thecal sacwithout significant central canal stenosis No significant change.C3-4: No significant disc disease. Bilateral uncovertebral spurring and bilateral facet arthropathy, mildlyprogressive since 5/19/2018. There is associated mild right and moderate to severe left foraminalnarrowing.C4-5, C5-6, C6-7, C7-T1: Postsurgical changes. No significant disc disease. Spondylitic ridging anduncovertebral spurring at C4-5, C5-6 and C6-7, mildly progressive since 5/19/2018. There is associatedforaminal narrowing, mild on the right at C4-5 and C5-6, mild on the left at C6-7. No significant foraminalnarrowing at C7-T1. No significant central canal stenosis at any of these levels.
    Spinal Canal Contents: Limited by CT technique, grossly unremarkable

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    Your CT notes; “C3-4: No significant disc disease. Bilateral uncovertebral spurring and bilateral facet arthropathy, mildly progressive since 5/19/2018. There is associated mild right and moderate to severe left foraminal narrowing’. If you had a posterior fusion at C3-4 along with your ACDF at the same level, you should have a facet fusion and “bilateral facet arthropathy” is probably post surgical changes. Make sure you know that the left formainal stenosis at C3-4 is your pain generator by a selective nerve root block with a pain diary before you push for surgery. See https://neckandback.com/treatments/epidural-injections-and-selective-nerve-root-blocks-diagnostic-and-therapeutic-neck/, and https://neckandback.com/treatments/pain-diary-instructions-for-spinal-injections-neck/ and
    https://neckandback.com/treatments/diagnostic-therapeutic-neck/

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
Viewing 6 posts - 25 through 30 (of 48 total)
  • You must be logged in to reply to this topic.