Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Diver
    Member
    Post count: 2

    I am a 48 year old male Have Had two Disc Replacements In 1994 C-6 C-7 bone In 2002 C-5 C-6 Bone With Plate screws NOW C-4 C-5 Needs to be replaced !
    I Want A Artificial Disc put in A proDisc-c But I don’t Want to Mess with 5 thru 7 Is it
    Posable to do that ? I Want to leave the plate alone and just do the C-4 C-5 Disc with A
    ProDisc-c CAN IT BE DONE ?

    yours truly
    Howard

    Thank you for your Time !

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    I assume that you mean by “disc replacement” in 1994 and 2002 that these were the typical ACDF (anterior cervical decompression and fusion) procedures. C4-5 has “worn out” and now needs surgery.

    The question is then can you have an artificial disc replacement (ADR) at C4-5 without disturbing the plate at C5-7?

    The answer is a qualified yes. As long as the plate was not placed “too proud” meaning that the upper boarder of the plate does not overlie the C4-5 disc space and of course you are a candidate for an ADR, that should not be a problem. See the section on cervical ADRs to understand the indications and contraindications for this procedure.

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.