Forum Replies Created

Viewing 7 post (of 7 total)
  • Author
    Posts
  • PhillyT
    Participant
    Post count: 9
    in reply to: Post ACDF issues #22108

    Many thanks for the reply Dr Corenman!

    I am currently under the care of Dr in NY at Columbia University Med Center. I hope he is a better surgeon than my last one who apparently used too small a tribecular metal interbody, and screws that are too short. Plus I hit my head 3 months after surgery which may have caused the collpase. So I’ll never know if it was the accident or not at this point. Are you familiar with Dr Riew? I hear is is very good, but that’s what everyone said about my last surgeon who screwed me up!!!

    What I do know is that the posterior side of my spine at 6/7 widens slightly when I’m in flexion, but the Xray and Cat scan can’t conclude fusion because of the artifacts created by the stupid metal interbody.
    Also, I am in a ton of dull achy pain when I look down in the slightest bit. So it makes sense that I’m not fused at this point.

    He says we need the nerve block to guarantee where the source of pain is, prior to treatment.

    If there is a lot of pain from 6/7 he wants to fuse posteriorly to stop the micro movements at this level, then flip me over and ACDF 7/1 in the event that the bone spur and disc herniation is the arm pain culprit at this level. I can’t even begin to imagine how painful this would be!!!!!!!!!!!!!!!

    Riew said foraminotomies at 7/1 will not guarantee the pain will stop there. That’s a bummer since I was not wanting another ACDF!!!

    But it makes sense if these two levels are causing pain.

    So confused, but I guess the nerve blocks will give me a better solution to get out of this debilitating pain.

    Thanks Dr!!
    Tom

Viewing 7 post (of 7 total)