Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • JeanElizab
    Participant
    Post count: 1

    I have a scoliosis thoracic curve 56 degrees lumbar is now about 40 degrees. I had an L2-L3 fusion at apex of lumbar scoliosis in 2014 and all was well for about 2 years. Now I am having shooting pain, likely from L5-S1 into left leg and a spine surgeon recommended I look into a scoliosis correction surgery- a very big deal but when the lumbar area goes “out” so to speak and there is a lot of facet arthritis too- i develop a twist in my body and it is excruciating i do not even face forward. This would be a mid thoracic to pelvic fixation if I understand it. I see my local surgeon next week. I am considering this option. But here is my question. I have developed neck pain also- I will cut and past the imaging results. For my neck I have tried cervical epidurals, facet blocks, prolotherapy, PT, chiro, acupuncture, massage. Te neck pain is such that there is NO comfortable position to lie down in. I am exhausted beyond belief. What happens if I need a ACDF- anterior cervical fusion, can I have a scoliosis correction too? Will I be able to turn to drive a car at all? I live by myself- female- age 57- just can not even comprehend what might happen to me. I live in a rural area. Everyone depends on a car, etc. But if I can not sleep, I can not live like this. I need some hammer toes corrected too but can not face lying on my back to have the surgery. Just had dental work and it pushed my bad neck over the edge. I will contact your office for an imaging review but before i see my local surgeon- really wondering what happends to people who have scoliosis fusions like mine then develop neck problems- how do they make it?

    The atlantooccipital and atlantoaxial alignment are maintained. There is anterior atlantodental arthrosis producing medium-sized superior osteophytes. No C1-C2 canal stenosis is present.

    C2-C3 : The posterior disc contour is maintained. There is no canal or foraminal stenosis. Mild left facet arthrosis is present.

    C3-C4: The posterior disc contour is maintained and there is no canal stenosis. Mild left foraminal stenosis is present. The right neural foramen is preserved. The facet joints are preserved.

    C4-C5: There is a small posterior disc protrusion, without canal stenosis. Uncovertebral and facet osteophytes contribute to mild to moderate left foraminal stenosis. The right neural foramen is preserved. There is moderate left facet arthrosis.

    C5-C6: Moderate loss of disc height is present. There is disc bulge which with posterior central disc protrusion and adjacent posterior endplate osteophytes contribute to mild to moderate canal stenosis. Uncovertebral osteophytes cause severe left foraminal stenosis. The right neural foramen is preserved. The facet joints are preserved.

    C6-C7: Moderate disc height loss is present. Disc bulge and adjacent posterior endplate osteophytes cause moderate canal stenosis. There is mild bilateral foraminal stenosis. The facet joints are preserved.

    C7-T1: Beam hardening artifact limits evaluation for soft tissue stenosis. There is no osseous canal or foraminal stenosis. The facet joints are preserved. Mild left costovertebral arthrosis is present.

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    The cervical spine is affected by a larger scoliosis due to the tilt of the T1 vertebra (it should be parallel to the ground). This tilt causes a curve in the neck too. This then causes asymmetric loading of the vertebra. This is something like knocking a car tire out of alignment. The tire wears more on one side than the other. Same with the cervical vertebra.

    An ACDF will be OK with a lower fusion as the neck “acts independently” to the thoracic and lumbar spines. What really needs to be looked at in your case is the X-rays as compared to the MRI. You certainly might need a cervical fusion but I cannot tell just by the cervical MRI what that fusion would look like.

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.