-
AuthorPosts
-
I have posterior rod and screws only on the left side of my neck i just had a ct that shows they are loose and have moved! I can feel them moving i am fully fused i am being told there is no way this is my source of pain cause that level can’t move because its fused so no one is concerned with the loose screws stating they can’t cause any harm
Well, if you were fully fused, you would not have loose rods and screws. Screws loosen due to motion. There is a very small possibility that you did go on to fusion even with the loose screws but I would doubt it. Find the radiologist report of the CT scan. Some radiologists will not call a fusion solid or not but at least this would be the next step. The radiologist works for the company that took the CT scan so start there.
Also, fixation only on one side commonly fails due to insufficient fixation.
Dr. Corenman
PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.Ct report says solid fusion. I should’ve clarified my last surgery in august 2017 i had redo acdf with my hip bone the posterior was done in may of 2017 the screws on right side were misaligned so he removed them leaving me with the left side only now those are loose and moving
If you have a solid fusion now, then the loose screws should not be a significant pain source. The screws, if protruding back too far can irritate the muscles and could be removed if needed.
Dr. Corenman
PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.All the pain is in the back of my neck on the side where screws are can’t even touch it! I have a weird clicking sound when i move my arms or try and take a drink! Are you saying that my acdf is fused there is no way the screws can move?
If you have a solid ACDF fusion now, those screws should not move. However, you could have a problem with a facet at a higher or lower level than the fusion.
Dr. Corenman
PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books. -
AuthorPosts
- You must be logged in to reply to this topic.