-
AuthorPosts
-
I have now had imaging done after the revision surgery. Nobody has mentioned the degree of fusion I have achieved at C6-7. I’ve been so concerned about feeling like my neck is stuck in an uncomfortable position that I haven’t thought to ask about the state of the fusion :)
Here are the images:
https://ibb.co/nbg4FR
https://ibb.co/jY0yaR
https://ibb.co/mgu226Unfortunately, I’ve seen no improvement in my pain or the sensation that my neck no longer achieves a comfortable resting position. My traps and suboccipital muscles are still constantly tense, despite physical therapy, stretching, acupuncture, active release therapy, etc. All of those therapies either provide no relief or very temporary relief. It’s bad enough that it makes it difficult to be upright for more than 30-40 minutes, and I’m concerned that I will have to go on disability if it doesn’t improve.
I also notice that it feels like my thoracic spine now has excessive kyphosis and my lordotic spine has excessive lordosis and my hips are angled more than before to compensate for the “extra curve” I feel in my neck. When I look in the mirror, it looks like my neck juts out more than it used to, where my head used to sit comfortably above my shoulders.
My range of motion seems fine in extension, but it’s so limited in flexion that it feels like I cannot look straight ahead like I used to. It feels like my upper cervical spine is all flexing much more than it used to to try and look straight ahead to compensate for the fused levels. It looks like the fusion at C6-7 was done at an extended angle, which seems in line with what I’m feeling. I notice that both surgeons fused it at approximately the same angle. My hunch is that if it were fused at less of an extended angle, I would be able to straighten my back like I used to, and the rest of my spine wouldn’t need to contort to accommodate that fusion angle. Do you know if there is anyone who would be willing to change the angle of fusion, if it’s not already too late? I’m in enough pain that it would be worth the risk for me.
If this kind of outcome isn’t expected, maybe I have some other deformity going on? I’ve always had a weirdly shaped torso with a barrel chest, prominent sternum, and large degree of kyphosis. I had some full spine x-rays done this past week but haven’t heard anything back on it yet. Here are the x-rays:
https://ibb.co/dNNVN6
https://ibb.co/nsPMUm
https://ibb.co/dGC89m
https://ibb.co/c0po9m
https://ibb.co/fauMUm
https://ibb.co/fiTFpmThanks again for your help!
I am sorry but I cannot open images off this forum due to viruses. You could either place the written radiological report here (as all images have to be dictated) or choose to have a “long distance consultation” which for a fee, I will review all your information and call you personally.
There is a film called a lateral scoliogram in which the entire head and body are captured on one film. This film allows analysis of the curves and balance of the spine. Due to your complaints, this might be a good film to have in your case.
Dr. Corenman
PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books. -
AuthorPosts
- You must be logged in to reply to this topic.