Viewing 6 posts - 1 through 6 (of 14 total)
  • Author
    Posts
  • kshabibi
    Member
    Post count: 17

    Hi Dr. Corenman,

    Over the past 1.5 year I’ve been having the following symptoms and it has gradually gotten worse.
    – Instability in hand – fine motor movements
    – Pins and needles in my left arm and hand
    – Cold feeling on my left arm
    – General weakness on my left arm and hand (can definitely feel it when trying to lift heavier objects
    – left leg is also a little weaker

    I’ve gotten multiple MRI’s over this time and the primary finding shows a disc bulge at C6-C7.

    The MRI findings are pasted below. Can u look through and help me with the following?

    1. I am leaning towards an ADR since I am 37. Would i be a good candidate? One of the dr’s I’ve seen is recommending ADR and another one said ADR is not necessary at c6-c7 since there is not much movement at that level.

    2. Can u help interpret the findings below? I am aware of the disc bulge and know what that means but am not sure if any of the other observations are concerning? Would I need multiple procedures to address all these issues? Or is the fusion or ADR good enough?

    I appreciate all the time and your professional opinion.

    Here’s the latest results from my MRI report:

    The C2-c3 interverteberal disc is normal.

    There is a small central protrusion at c3-c4 with mild disc bulge, causing mild bilateral neural foraminal stenosis

    There is a mild disc bulge at c4-5 without significant stenosis

    At the c5-c6 level, there is a left central ostephyte protrusion causing mild central canal stenosis. There is a mild bilateral neural foraminal stenosis, left greater than right.

    There is a focal disc protrusion at c6-c7 spanning 7mm in the AP dimension and deforming the left ventral hemicord. There is a mild to moderate left nueral foraminal stenosis and mild right nueral foraminal stenosis as well

    The C7-T1 intervertebral disc is normal

    IMPRESSION:
    1. Left central disc protrusion at c6-c7 with underlying disc bulge, causing moderate to severe central canal stenosis with ventral cord deformity as well as moderate left and mild right neural foraminal stenosis.
    2. Left central disc osteophytic protrusion at c6-c6 causing mild central canal stenosis and bilateral neural foraminal stenosis, left greater than right.
    3. Mild bilateral foraminal stenosis at c3-c4 related to disc bulge with small superimposed central protrusion

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    First, the symptoms must match the pathology. Your report notes a “focal disc protrusion at c6-c7 spanning 7mm in the AP dimension and deforming the left ventral hemicord. There is a mild to moderate left neural foraminal stenosis and mild right neural foraminal stenosis as well”.

    This C6-7 compression can cause some cord dysfunction as well as nerve root dysfunction on the left. This fits with your symptoms so based upon this short review most likely these symptoms match the imaging findings. A physical examination as well as a thorough history would cement this diagnosis. We will assume that these inquires would match with the findings.

    This means you are a candidate for an ACDF or an ADR at the C6-7 level. When then is each indicated and what are the positives and negatives?

    An ACDF is the tried and true decompression and fusion that is reliable and permanent. Once the level is decompressed, a fusion will stop the motion between the two segments and this level will never bother you again.

    The complaint with this procedure is that there is some increased stress brought to the levels above and below. However, most levels that are fused are already very stiff so that argument does not hold much water.

    If a normal level should normally move 20 degrees and prior to fusion moves only 3 degrees due to the degeneration (which is a very common scenario), fusion makes very good sense. Stress transfer is already occurring without any surgical intervention.

    Now ADR (artificial disc replacement) is designed to allow motion when implanted. This procedure allows you to decompress the level (take pressure off the nerve root and spinal cord) which is the primary reason for the surgery but preserves motion.

    There are caveats. This disc replacement cannot be placed in a situation where the level is so degenerative that there is little motion to begin with. In addition, if there is degenerative facet disease present in this level (the joints in the back of the spine), additional motion of this level (which is the purpose of the ADR) can cause increased pain and premature failure of this artificial disc.

    ADRs were designed to reduce the stress transfer to the levels above and below by allowing some motion. This stress transfer reduction by and ADR has not been helpful to reduce adjacent level degeneration. That is, degeneration seems to occur in the levels above and below in the same percentages as if you had an ACDF (fusion).

    So what is the benefit of an ADR over an ACDF? Continuing motion of the segment that needs surgery. Is this helpful? The answer is yes as the neck will have more motion that if a fusion is performed. Will the ADR benefit the levels above and below. No. This device does not protect the levels above or below.

    Are there any downsides to an ADR. Yes. This is a mechanical device and has a certain lifespan. That is, it will eventually wear our and need to be replaced with a fusion. How long will that take? There is no specific timetable that has been reliable at this point. I have revised about 10 ADRs at this point. Nine were not my own but I have had to revise one of my own.

    So is an ADR a good idea? The answer is mixed. If the level that needs surgery is a candidate for an ADR (and in my opinion, only about 20-30% of levels are candidates), then you have to consider the pluses and minuses of an ADR. This device will allow more range of motion but will eventually need to be replaced in a future surgery. It will not preserve the levels above or below.

    This is the patients decision.

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
    kshabibi
    Member
    Post count: 17

    Thank u for the detailed reaponse. If u dont mind me asking what were the problems with the adrs u had to revise. I have heard placement of the adr is important.

    I uave also bee, having weaknes and minor burning numbness in my left leg. Do u think that is related?

    kshabibi
    Member
    Post count: 17

    Also my movement right now is pretty good. The doc took xrays of flexion and he said they were good
    My chief complaint is not necesaarily pain but my numbness tingling and weakness.

    One umexplained symptom is crunching in my neck when i look to the left and then back to center. It almost feels like bones are rubbing and feels like sometimes something is catching and then releases if i shift my neck certain way. Woukd this be indicatuve of facet joint issue or something else?

    Donald Corenman, MD, DC
    Moderator
    Post count: 8660

    The ADRs I had to revise had to do with angulation changes or pain. The bony endplates of the vertebra have to support the metal endplates of the disc replacement. There are times with overload that the vertebral endplates fracture and the disc settles or angles abnormally.

    This creates pain due to bone overload or nerve compression. The disc needs to be replaced by a fusion at this point.

    I have started to use the Bryan disc lately and I find this disc to have a better design. This disc had shock absorption added which many of the other discs on the market do not have. This disc might hold up better than the others but there is one caveat.

    The shock absorption characteristic is brought about by a semipermeable membrane that absorbs water to form the cushion for shock absorption. What the life expectancy for this membrane is still unknown.

    Dr. Corenman

    PLEASE REMEMBER, THIS FORUM IS MEANT TO PROVIDE GENERAL INFORMATION ON SPINE ANATOMY, CONDITIONS AND TREATMENTS. TO GET AN ACCURATE DIAGNOSIS, YOU MUST VISIT A QUALIFIED PROFESSIONAL IN PERSON.
     
    Donald Corenman, MD, DC is a highly-regarded spine surgeon, considered an expert in the area of neck and back pain. Trained as both a Medical Doctor and Doctor of Chiropractic, Dr. Corenman earned academic appointments as Clinical Assistant Professor and Assistant Professor of Orthopaedic Surgery at the University of Colorado Health Sciences Center, and his research on spine surgery and rehabilitation has resulted in the publication of multiple peer-reviewed articles and two books.
    kshabibi
    Member
    Post count: 17

    Yeah my dr. Is planning on using the bryan disc. Does thst disc use screws as well? If u personally had the option of going with adr or fusion what would u opt for knowing everything uve seen? Thanks

Viewing 6 posts - 1 through 6 (of 14 total)
  • You must be logged in to reply to this topic.